Rockhard Industrial Rebar Cutter (Made in USA)

Problem-Solver Performance for Concrete Reinforcement

The Rockhard Industrial Rebar Cutter is the essential tool for drilling through tough concrete and quickly resolving unexpected encounters with rebar. Proudly Made in the USA and engineered for maximum durability, this cutter turns your standard equipment into a specialized solution.

Designed for use in any 1/2" drill motor with a 3-jaw chuck, this tool allows concrete work to proceed when traditional bits fail due to embedded steel.

CRITICAL OPERATING GUIDELINES (Rotation Only):

• Mode: Rotation Mode ONLY is required. The percussion (hammer) mode will damage the tool and void the suggested usage.

• Technique: Use low RPMs and maintain ample operator pressure.

• Maintenance: Always remove the steel "slug" from the cutter or hole immediately after cutting to prevent jamming and premature wear.

• Cutting: Dry cut recommended for best results.

• Compatibility:

  • Sizes 7/8" through 1-3/4" utilize a 1/2" - 13 thread size.

  • Sizes 2" and 2-1/2" utilize a 3/4" - 10" thread size.

IMPORTANT CAUTION & LIMITATIONS:

Rebar cutters are designed as problem-solvers to penetrate steel reinforcement encountered during concrete drilling. They should NOT be used for general concrete drilling. Performance can vary based on the specific application and how the rebar is engaged.

Note: Due to the extreme, problem-solving nature of this application, Rockhard Rebar Cutters are not warrantied for repair or replacement.